Flex in OBD for Iveco MD1CS069

Iveco Bosch MD1CS069 Now Ready

The new update for Magic Motorsport Flex ECU Programmer, version 7.49.0.0, is now available and introduces OBD programming for the latest Iveco Daily vehicles equipped with the Bosch MD1CS069 engine control unit, including models produced after 2021.

Thanks to this new protocol, you can now work directly through the vehicle’s diagnostic OBD port (with the option to bypass the SGW Secure Gateway module) or establish a direct connection through the ECU connector.

From now on, working on the map area does not require unlocking the control unit or shipping it to the manufacturer. You can easily:

  • remove DTC errors

  • increase engine performance

  • reduce fuel consumption

—all within a few minutes.

Some of the Supported Vehicles

Examples of supported models:

  • Iveco Daily (IV) 2.3L FPT 16v 134HP

  • Iveco Daily (IV) 3.0L FPT 16v 177HP

New Protocol Available for the Following Software Packages

OBD

  • FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

  • FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

  • FLS0.5M – SW Flex Full Master

  • FLS0.5S – SW Flex Full Slave

Newly Added Protocol

OBD

  • Iveco Bosch MD1CS069 TC299 – Read / Write / Checksum Calculation Maps

Working Time

  • Writing time: ~2 minutes

  • Reading time: ~5 minutes